Shenzhen Bropool Industrial Co., Ltd. is a professional manufacturer on sauna room, hot tub and cold plunge
Tel:+86 18928448819 E-mail:info@bropool.com
2024-08-01 attribution:News
1. The most common problem is that after the decoration of the steam room, the power cannot be turned on, and the switch will be turned off immediately. This is obviously due to electrical leakage. This type of fault is mostly caused by the wet cement directly contacting the electric heating film when the floor tiles are placed on the ground, which leads to electrical leakage. This situation is very common. Solution: What is the reason why the power supply in the sweat steam room cannot be turned on
2. The thermostat always breaks down. After the sweat steam room is installed, it breaks down after a short period of time. The sweat steam room has malfunctioned multiple times in a row. The main reason for this phenomenon is that the load on the thermostat is too high, causing it to burn out.
3. The communication contactor keeps ringing, which was fine a while ago, but recently it has suddenly started to make loud noises.
4. The temperature rise in the sweat steam room is getting slower and slower, which is usually due to the loss of heat from the heating element. Its power is decreasing, so the heating time will become longer and longer.
5. The steam room consumes a lot of electricity, and if there is a power outage, the temperature will drop.
6. The floor of the sweat steam room suddenly becomes unevenly heated, which often occurs on the electric heating film
7. The collapse of the floor in sweat steam rooms is also a common problem that many sweat steam rooms are prone to. Solving this problem is often a headache because of its high cost. So the best solution is: the reason for the collapse of the floor of the sweat steam room and the repair method
Read recommendations:
The room tripped as soon as it was started, how could it happen