What are the installation and construction steps for the sweat steaming room?timberline wood fired hot tub heater

　　Suspend the ceiling, keep the top insulated, and install the ceiling cloth. The shapes of the ceiling are diverse, with Korean style sweat steaming rooms often using ceiling cloth, Enron sweat steaming rooms using nano quilts, and there are also other materials used. Korean style sweat steaming rooms can be painted with energy powder on the ceiling or without the ceiling, all painted on the wall, with the same effect. Mix the energy powder and putty powder of the ceiling and hang them on the gypsum board or wooden board of the ceiling. Pay attention to reserving light lines for the suspended ceiling. The ceiling cloth needs to be tightened, and one side can be fixed first, and then the other side can be fixed after tightening.

　　Wall bound wooden keel frame. Install the extruded board, embed it in the wooden keel, and keep the wall flat. Install gypsum board on the upper layer of the extruded board. The function of gypsum board is to level the wall surface and facilitate the fixation of other materials. Reflective film and electric heating board are installed on the wall surface, and electric heating board is installed and connected to the temperature controller. The built-in temperature sensor of the temperature controller is installed and tested for power on. Decorate the wall after confirming that there are no abnormalities. When the probe is not long enough, a copper core wire of the same thickness can be used to extend it. It is recommended to use a telephone signal wire.

　　The outer layer of the electric heating board is laid with non-woven fabric (non-woven fabric is used to hang energy powder, Enron Nano sweat steam room is not laid), and bamboo curtains are installed. Mark them well, and do not nail them onto the heating area and wires of the electric heating board when driving nails. When installing the backrest, do not nail it onto the heating area of the electric heating plate and wires. Construction and installation sequence of ground electric heating board: first layer: lay extruded plastic board; second layer: lay reflective film; third layer: lay electric heating board. If laying floor tiles, the electric heating board needs to be covered with a special bag. Fourth layer: lay waterproof cloth, overlapping each other by 15CM (if laying floor leather, waterproof cloth can be omitted) Fifth layer: floor, floor tiles, etc. If laying floor tiles, please mix a large bag of high-energy powder with sand to make 2-3CM thick, and then stick the floor tiles. To lay the floor, energy powder can be directly sprinkled under the floor for use.

　　When installing household sauna equipment, it is necessary to find a professional sauna company. Professional personnel should be responsible for professional tasks, as they have an electrician's certificate, trained personnel, and extensive experience in sauna construction. Do not just find someone who knows something about electricity

　　After some construction site masters have completed their work, what should they do if the home decoration is not yet completed and the wires are not connected to the sauna room? Firstly, it is necessary to have a professional electrician connect the electricity. Secondly, it is necessary to first ask the sauna room decoration master how the circuit runs. When connecting, it is necessary to pay attention to safety, turn off the main power, and do personal protective work before starting. Methods such as reducing voltage, strengthening grounding, increasing leakage protection, and adding isolation transformers can be used to install the circuit.

　　In short, professional matters should be entrusted to professional personnel. Regardless of the price of household sauna equipment, safety must be the top priority.

Read recommendations:

Cold Hydrotherapy sales

Cold Plunge CT-13

Cold Plunge CT-01

hot tube outdoor woodfire Procurement

Hot Tub Retreat.The benefits of sweating and steaming